2 Door Hardtop
V0E: 440 390HP 3-2BBL 8 CYL
Los Angeles, CA, USA
: Sequence number
E87: 440 cid 3x2 barrel V8 (High Performance) 390hp
D21: 4 Speed Manual Transmission
EV2: Hemi Orange Exterior Color
H6XW: Trim - High, Vinyl Bucket Seats, Black/White
000: Full Door Panels
C08: Build Date: December 08
050842: Order number
V1W: Full Vinyl Top, White
A33: Track Pak w/3.54 ratio
A62: Rallye Instrument Cluster Package
C55: Bucket Seats
G36: OS Dual Racing Mirrors
J25: 3 Speed Wipers
J45: Hood Tie Down Pins
J81: Rear Spoiler - Wing Type
M21: Roof drip rail moldings
M25: Wide sill moldings
M31: Belt Moldings
M88: Decklid Moldings Treatment
N41: Dual Exhaust
N42: Chrome Exhaust Tips
N96: Fresh Air Hood
R22: AM Radio with 8 Track (10 Watts)
V5W: Body Side Stripes, White
26: 26in Radiator
END: End of Sales Codes
This is an original true 440 six-pack, pistol grip hemi 4 speed,dana 60 car with Fresh air Shaker hood and deck wing. Factory EV2 hemi orange body color.
Car is stripped down and disasembled. I have most of the parts.. lots of boxes of parts. Body is stripped down and primed with epoxy primer. I did paint the engine compartment and radiator support in EV2 paint. Fenders i did not strip yet. Doors I stripped down to the original orange. Not a rust bucket. Nice solid car. It does have a couple small holes in front and rear window channel where glass sits in. Lower drivers quarter behind rear wheel does have some pinholes starting... night need patch in lower 6-8" of quarter. I have an entire quarter for it... but should only need the lower 8" replaced. Othewise the car and frame rails are solid. Would be hard to find a car this solid. It did have a roll cage, ladder bars and weld in subframe connectors. I removed the roll cage. The subframe connectors still in the floor. Roof has a couple small oilcans. But fixable. I do not have the vinyl roof trim. Prior owner removed vinyl roof.
I do not have the original engine for it. No engine included. It is long gone. It is rolling on 8 3/4" rear.... I do know where the original dana 60 is but it had ladder bar mounts and wheelie bar mounts welded to it. I was just going to get a new dana 60. I have the hemi 4 speed trans... it is disassembled. I have the pistol grip shifter... it needs one tab for linkage repaired.
I have all glass and new windshield for it. Interior needs to be redone. Have shaker hood, bubble and air cleaner. Have the grill but most likely it would be cheaper to get a better one. Center part of grill really rough. Bumpers need to be rechromed.
I have many parts for it. I should have pictures in a day or two.